Regency U32-LP4 User Manual

U32-4 FPI Direct Vent Gas Insert

To remove the fl ush door, reverse the above 
steps.

NOTE: The chain must rest on TOP of the gas 
inlet pipe never under it.

Use the hook to pull the spring out until you 
can put the hook into the slot on the bottom 
door bracket. Repeat for 2nd spring.  See 
diagram 3.
 

Attach 2 round magnets to the back of the top 
trim piece and the other 2 to the bottom trim 
piece, then attach trim to the top and bottom 
of Flush door.

The standard fl ush door comes with a black 
frame. To install the frame, simply hook the top 
door fl ange onto the top of the unit and swing 
the door towards the unit, diagram 1. Be careful 
that the glass gasket does not roll up; there 
must be a gap between the gasket and the door 
lip to ensure that the door sits securely on the 
unit. Diagram 2.

Diagram 5.

11) Push the Regency

®

 logo plate into the 

3)  Open the screen door(s) and secure the 

screen door to the fl ush door front with 2 
clips on the bottom left and right side. 

1)  Pull out the top 

louver.

2)  C e n t e r   t h e 

screen door 
and hook over 
the fl ush door.

1)  The top louver is held in place by friction fi t, 

if the louver needs to be adjusted; bend the 
bracket out as shown in the diagram.