Regency U32-LP4 User Manual

U32-4 FPI Direct Vent Gas Insert

1)  Install top louver by sliding the two bracket 

clips into the brackets located on top of the 
bay door. See below. The fi tted louver leaves 
a small gap between faceplate bottom and 
louver top.

Attach the 4 supplied magnets, each to the 
back of the top and bottom trim pieces (space 
out evenly) and attach trim to the top and bot-
tom of Bay door. 

2)  Install bottom louver by sliding the two 

bracket clips into the brackets located 
underneath the bay door. Secure with 1 
screw into each Bottom Louver Mounting 
Bracket as per diagram below. Use the 
bottom hole in the bracket.

The optional Bay door is an overlay on the 
fl ush front. The standard fl ush door and glass 
must remain on the unit. Hook the top of the bay 
door over the fl ush door fl ange and swing the 
bottom against the bottom fl ange of the fl ush 
door. Press down on the Bay Bottom bracket 
and push in until  it clips behind the bottom of 
the fl ush front.

3)  Slide the valve extension knobs onto the 

valve knobs. Match each extension knob with 
the corresponding valve knob. Extension 
knobs are for Bay Front installations 
only.

To remove only the Bay Door - use a screwdriver 
to unclip the Bay Bottom bracket from the fl ush 
door and then swing up and unhook from the 
top fl ush door fl ange.

To remove the Bay Door & the Flush Front 
together, pull the hook from the slot in the 
bottom door bracket under the unit (see Standard 
Flush Door instructions above). Then pull the 
Bay Door and Flush door out and lift off of the 
fl ange at the top of the unit.

2)  Install the Spring Hinges on the left and right 

side of the bottom of the Firebox using 2 
screws per hinge.

3)  Place the Bottom Louver near the hinge. Flip 

hinge over the Bottom Louver and secure 
using 3 screws.