Regency L900-LP User Manual

Regency

®

 L900 Direct Vent Gas Fireplace

MAINTENANCE

3)   Loosen the 2 screws that hold the left side  

heat shield in place.

4)   Lift up and pull out the heat shield slightly 

to clear the screwheads and then hang it 
on the top bracket (located directly above 
the heat shield).

8)  Remove the battery cover from the DC 

Sparker Box.

9)   Disconnect all the wires and connectors 

from the DC sparker.

10) Remove the 2 screws that hold the DC 

sparker.

1)   Remove the exterior brick panels.

2)   Remove the glass door.

 

a.  Release the 2 door latches on the left      
     and right side at the top of the fi rebox.

 b.  

 Swing the door out from the top and release   
the hinges on the left and right side of the  
door by lifting them up.

11) Replace the DC sparker.

12) Reverse steps to re-install.

6)  Loosen the 2 screws that hold the right  

side heat shield.

7) Lift up and pull out the heat shield slightly to 

clear the head screws and then hang it on 
the top bracket (located directly above the 
heat shield). 

5)  Unplug the power source.