Regency P48-2 User Manual

Regency

®

 P48-2 Zero Clearance Direct Vent Gas Fireplace

1)  Run the supplied 15' of wire through the 

back gas inlet opening. Be careful not to 
damage wire.

2)  Connect the wire to the supplied wall switch 

and install into the receptacle box.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

50 Ft.
32 Ft.
20 Ft.
12 Ft.

9 Ft.

Wire Size                       Max. Length

A wall thermostat may be installed if desired, 
connect the wires as per the wiring diagram in 
"Wiring Diagram" section. Use the table below 
to determine the maximum wire length.

Regency

®

 offers an optional programmable 

thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

Use the Regency

®

 Remote Control Kit  approved 

for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace 
to that location. Use the Thermostat Wire 
Table.

2)  Connect the two wires to the gas valve. See 

diagram.

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.