Regency L234-LP User Manual

Regency

®

 L234 Direct Vent Gas Insert

INST

ALLA

TION

3)  Attach the top piece of the backing plate to the faceplate using 5 

screws provided as shown in diagram 1.

4)  Place the 4 10-24 x 1/2" screws into the faceplate mounting brackets 

as identifi ed in diagram 2. Screws are provided with faceplate 
packaging.

1)  Remove the faceplate (Contour or Contemporary) from the unit if 

already installed.

2)  Lay the faceplate on its front, on a soft surface to prevent 

scratching.

The inside of the backing plate 

may be cut as required using a 

metal cutting blade.

Do not cut the outside edges.

The Backing Plate can be adjusted to custom fi t an installation by trimming 
the inside of the top, corner and side pieces as shown in the diagram 
below. The dotted lines shown are only an example of where you can 
cut. Cuts can be made beyond these marks as required.

Trim the backing plate using a metal cutting blade. No cut edges will be 
exposed once installation is complete.

NOTE: In place of where any existing screw holes are cut, new holes 
will need to be drilled for attachment.

9 

Screws (#8 x 1/2" Type B Black)

1 Backing 

Plate

Diagram 1

Diagram 2