Empire Comfort Systems CHBR-16-3 User Manual
Page 5
16934-3-0806
Qualified Installing Agency
Installation and replacement of gas piping, gas utilization equipment
or accessories and repair and servicing of equipment shall be
performed only by a qualified agency. The term "qualified agency"
means any individual, firm, corporation, or company that either in
person or through a representative is engaged in and is responsible
for (a) the installation, testing, or replacement of gas piping or (b) the
connection, installation, testing, repair, or servicing of equipment;
that is experienced in such work; that is familiar with all precautions
required, and that has complied with all the requirements of the
authority having jurisdiction.
State of Massachusetts: The installation must be made by
a licensed plumber or gas fitter in the Commonwealth of
Massachusetts.
Sellers of unvented propane or natural gas-fired supplemental
Sellers of unvented propane or natural gas-fired supplemental
room heaters shall provide to each purchaser a copy of 527 CMR
30 upon sale of the unit.
In the State of Massachusetts the CHBR-16 must be secured
In the State of Massachusetts the CHBR-16 must be secured
to the floor.
The installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code, ANSI Z223.1.*
*Available from the American National Standards Institute, Inc. 11 West 42nd St.,
New York, N.Y. 10018.
IMPORTANT: Read all instructions carefully before starting
installation. Failure to follow these installation instructions may
result in a possible fire hazard and will void the warranty.
Save this manual for future reference.
Please read this manual before installing and using the
Save this manual for future reference.
Please read this manual before installing and using the
appliance.
Instructions to Installer
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
2. Installer must have owner fill out and mail warranty card supplied
with unvented room heater.
3. Installer should show owner how to start and operate unvented
room heater.
Always consult your local Building Department regarding
regulations, codes or ordinances which apply to the installation
of an unvented room heater.
This appliance may be installed in an aftermarket* manufactured
This appliance may be installed in an aftermarket* manufactured
(mobile) home, where not prohibited by state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on
the rating plate. This appliance is not convertible for use with
other gases.
Any alteration of the original design, installed other than as shown
Any alteration of the original design, installed other than as shown
in these instructions or use with a type of gas not shown on the
rating plate is the responsibility of the person and company making
the change.
INTRODUCTION
SPECIFICATIONS
Manifold Pressure
Natural Gas
Propan Gas
Regulator pressure setting 3.5" W.C.
Regulator pressure setting
10.0" W.C.
Gas inlet pressure
Max. 10.5" W.C. Gas inlet pressure
Max 13.0" W.C.
Min. 5.0" W.C.
Min. 11.0" W.C.
Model
CHBR-16
Input Maximum Btu/Hr
Minimum Btu/Hr
20,000
14,000
Height
49"
Width
23"
Gas Inlet
3/8"
ACCESSORIES
Product
No.
Description
CHG-VF
Antique Green Chimenea
CHR-VF
Terra Cotta Red Chimenea
FRBC-1
Battery Operated Remote Control
FRBTC-1
Battery Operated Remote Control with Thermo-
stat
FREC-1
Electri Remote Control
FWS-1
Wall Switch