Desa Air Conditioner User Manual

Page of 18
www.desatech.com
113893-01B
7
POSSIBLE CAUSE
1. No electrical power to heater
2. Fan  hitting  inside  of  heater 
shell
3. Fan blades bent
4. Defective motor
1. User did not follow installa-
tion or operation instructions 
properly 
2. No spark at spark plug. To test 
for spark, follow step 8 under 
Spark Plug, page 9. If you see 
spark at spark plug, have heater 
serviced by qualified service 
person. If no spark seen:
  A)  Loose  or  disconnected 
spark plug wire
  B) Bad spark plug
  C) Bad spark transformer
1. Propane supply may be inad-
equate
2. High  surrounding  air  tem-
perature causing thermal limit 
device to shut down heater.
3. Restricted air flow
4. Damaged fan
5. Excessive  dust  or  debris  in 
surrounding area
REMEDY
1. Check  voltage  to  electrical 
outlet.  If  voltage  is  good, 
check heater power cord for 
breaks
2. Adjust  motor/fan  mount  to 
keep fan from hitting inside of 
heater shell. Bend fan mount 
if necessary
3. Replace fan. See Fan, page 8
4. Replace  motor.  See  Motor
page 8
1. Repeat installation and opera-
tion instructions. See Instal-
lation, page 4 and Operation
page 5
2. A)  Check  spark  plug  wire. 
Tighten or reattach loose spark 
plug wire. See Figure 8, page 9 
for spark plug wire location
  B)  Replace  spark  plug.  See 
Spark Plug, page 9
  C) Replace spark transformer. 
See Spark Transformer, page 9
1. A) Refill tank
  B) Provide additional and/or 
larger  tanks.  See  Propane 
Supply, page 4
2. This can happen when running 
heater in temperatures above 
85° F (29° C). Run heater in 
cooler temperatures
3. Check heater inlet and outlet. 
Remove any obstructions
4. Replace fan. See Fan, page 8
5. Clean  heater.  See  Mainte-
nance, page 6
OBSERVED PROBLEM
Fan does not turn when heater 
is plugged in
Heater will not ignite
Heater shuts down while run-
ning
TROUBLESHOOTING
 WARNING: Never service heater while it is plugged in, connected 
to  propane  supply,  operating  or  hot.  Severe  burns  and  electrical 
shock can occur.
 WARNING: Use only in areas 
free of high dust content.