Quadra-Fire 32198A User Manual
Page 23
32198A February 15, 2002
32198A February 15, 2002
Cape Cod Wood Stove
R
INSTALLATION
ASSEMBLY
1 Place the unit in a location near the final installation area and follow the procedures below:
2 Open the stove and remove all the parts and articles packed inside. Inspect all the parts and cast iron body for
shipping damage. Contact your dealer if any irregularities are noticed.
3 Install floor protection if the heater is being placed on a combustible floor. Refer to the section on floor protectors
for required materials and sizes on page 10.
4 REMOVE ANY LABELS FROM GLASS.
5 DO NOT TILT THE UNIT ON THE CAST IRON LEGS: Lift the unit upright and place it into position
on the floor protector.
6 Ensure that the kaowool insulation is positioned snugly against the rear of the unit, (see page 33, for kaowool blanket
location). This eliminates any unburned gases from escaping prior to burning.
REVERSIBLE FLUE COLLAR
The Cape Cod flue collar is reversible for either a top or rear venting installation. The unit is shipped with the flue collar
in the top vent position. For rear vent installations adjust the flue collar as follows:
1. Remove 6 Phillips head screws from the vent collar shield, remove shield and discard.
2. Remove bolts from each side of the flue transition (2 total). (Place your free hand in flue opening to locate
and retrieve nuts attached to bolts.)
3. Turn vent. Replace bolts and nuts.
FIREBRICK PLACEMENT
Ensure that the firebricks are correctly positioned as referenced by diagram below, and that the firebox does not contain
any broken brick prior to operating the unit.
Part Numbers
834-3870 Brick Set
832-0550 Individual Brick
9.00
8.25
4.50
3.75
9.00
8.50
1.35
9.00
7.50
4.50
3.00
6.31
1.35
9.00
4.50
6.00
4.50
4.50
2.00
6.00
2.50
1
12
2
3
4
5
6
7
8
9
10
11
13
14
15
16
17
18
j
k
l
m
n
o
p
q
r
s
11
12
13
14
15
16
17
18