Roberts Radio RecordR User Manual

1.  Fully extend the telescopic aerial. The aerial should be fully extended 

and positioned vertically for optimum reception.

2. Press 

the 

On / Off button to switch on your radio.

3.  Press and release the Band button until the FM band is selected.
 
4.  Press and release the Tuning Up button to cause your radio to search 

from low frequency to high frequency and to stop automatically when 
it fi nds a station of suffi cient strength.

 

Note: If your radio does not auto scan, press and release the Select 
button until the display shows 'Auto Scan: ON'.

5.  After a few seconds the display will update. The display will show the 

frequency of the signal found. If the signal is strong enough and there 
is RDS data present then the radio will display the station name.

6. To fi nd other stations press and release the Tuning Up button as 

before.

7.  Press and release the Tuning Down button to cause your radio to 

search from high frequency to low frequency and to stop automatically 
when it fi nds a station of suffi cient strength. When the end of the 
waveband is reached your radio will recommence tuning from the 
opposite end of the waveband.

8. Adjust 

the 

Volume and Tone controls to the required setting.

9.  To switch off your radio press the On / Off button.

Note: 
If you fi nd that FM reception is poor, try repositioning the Telescopic aerial. 
Fully extend and position vertically for optimum reception. If you fi nd that 
an FM broadcast has a lot of background hiss, this may often be reduced 
by setting the radio into Mono reception mode for the current FM station. 
Please refer to the section "Stereo / Mono setting - FM" on page 16 for 
further details.

3

7

4,6

8

8