Roberts Radio RecordR User Manual

1.  Fully extend the telescopic aerial. The aerial should be fully extended 

and positioned vertically for optimum reception.

2. Press 

the 

On / Off button to switch on your radio.

3.  Press and release the Band button until the FM band is selected.

4.  Press and release the Select button until the display shows 'Auto 

Scan: Off'.

5.  Repeatedly press and release the Tuning Up or Down buttons to 

tune to a station. The frequency will change in steps of 50kHz.

 

If the radio is tuned to a station of suffi cient signal strength with RDS 
information present, then the display may change to show the station 
name.

6.  When the waveband end is reached the radio will recommence tuning 

from the opposite waveband end.

7. Adjust 

the 

Volume and Tone controls to the required setting.

8.  To switch off your radio press the On / Off button.

Note: If you fi nd that FM reception is poor, try repositioning the Telescopic 
aerial. Fully extend and position vertically for optimum reception.If you 
fi nd that an FM broadcast has a lot of background hiss, this may often 
be reduced by setting the radio into Mono reception mode for the current 
FM station. Please refer to the section "Stereo / Mono setting - FM" on 
page 16 for further details.

3

5

5

7

7

4