Dimplex DS7425DLX User Manual

5

WARNINg: Disconnect power before attempting any 

maintenance or cleaning to reduce the risk of fire, 

electric shock or damage to persons.

Allow at least five (5) minutes for light bulbs to cool off 

before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark 

section of the flame or when the clarity and detail of the log 

exterior disappears. 

There are three (3) bulbs under the Log Set Assembly, 

which generate the flames and embers, and one (1) bulb 

above that illuminate the log exterior.

Tool Requirements: Phillips screw driver
Helpful Hints:  It is a good idea to replace all light bulbs 

at one time if they are close to the end of their rated life.  

Group replacement will reduce the number of times you 

need to open the unit to replace light bulbs.

Upper Bulb Requirement:  Quantity of one (1) 7 Watt 

candelabra E12 small base 120 volt. 
Do not exceed 7 Watts per bulb.
Upper Bulb Replacement  (Figure 5)

Open door by pulling the handle.

1. 

Locate the upper bulb bracket.

2. 

Bend light retainer bracket down.

3. 

Locate and remove light bulb.

4. 

Insert and install new bulb.

5. 

Bend light retainer bracket back into its original 

6. 

position.
Close the door.

7. 

Lower Bulbs Requirement:  Quantity of three (3) 35 Watt 

Halogen Quartz lamps, 120 volt, G9 Base. 
Do not exceed 35 Watts per bulb.
Lower Bulb Replacement

Remove the stove pipe kit (if equipped).

1. 

Gently place stove on its back on a flat surface.

2. 

Remove the heater cover retaining screws located on 

3. 

the bottom of the stove (Figure 6) and lower heater and 

light assembly out onto the floor.
Remove the burnt out bulb(s) by pulling straight out 

4. 

of socket. If bulbs are difficult to remove form socket 

move the bulb from side to side while pulling being 

careful not to damage the light socket.
Replace the lower light bulbs.

5. 

Reassemble in the reverse order as above.

6. 

The clear door is cleaned in the factory during the 

assembly operation. During shipment, installation, handling, 

etc., the clear door may collect dust particles. These can be 

removed by dusting lightly with a clean, dry cloth.
To remove fingerprints or other marks, the clear doors 

can be cleaned with a damp cloth. The clear door should 

be completely dried with a lint free cloth to prevent water 

spots. To prevent scratching, do not use abrasive cleaners 

or spray liquids on the clear door surface.

To remove fingerprints or other marks, the clear doors 

can be cleaned with a damp cloth. The clear door should 

be completely dried with a lint free cloth to prevent water 

spots. To prevent scratching, do not use abrasive cleaners 

or spray liquids on the clear door surface.

Use warm water only to clean painted surfaces of the 

Stove. Do not use abrasive cleaners.

Except for light bulb replacement and cleaning described 

above, an authorized service representative should perform 

any other servicing.

Screws

Screws