Manualsbrain.com
  1. Manuals
  2. Brands
  3. ONKYO
  4. 29344937
  5. User Manual

ONKYO 29344937 User Manual

Download
Page of 100
81
If you’ve connected your Zone 2 speakers to the AV 
receiver, as explained in “Connecting Your Zone 2 
Speakers Directly to the AV receiver” on page 80, you 
must set the “PwrdZ2” (Powered Zone 2) setting to 
“Act” (Activated).
Notes:
• When “Act” is selected and Zone 2 turned on, the 
Zone 2 speakers connected to the ZONE 2 
SPEAKERS L/R speaker terminals output sound, but 
the surround back speakers connected to the SURR 
BACK L/R speaker terminals do not. When “Act” is 
selected and Zone 2 turned off, the surround back 
speakers output sound as normal.
• When the “Powered Zone 2” setting is set to “Act” and 
the input selector of Zone 2 is selected, power con-
sumption on standby mode slightly increases.
• “Powered Zone 2” cannot be used if “Sp Type” is set 
to “Bi-Amp” (page 44).
• This procedure can also be performed on the AV 
receiver by using its [SETUP] button, arrow buttons, 
and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button, 
followed by the [SETUP] button.
2
Use the Up and Down [
q]/[w] 
buttons to select “2. Speaker 
Setup”, and then press [ENTER].
SETUP
RECEIVER
qwer
ENTER
3
Use the Up and Down [
q]/[w] 
buttons to select “2-1. Sp 
Settings”, and then press 
[ENTER].
4
Use the Up and Down [
q]/[w] 
buttons to select “PwrdZ2”.
5
Use the Left and Right [
e]/[r] 
buttons to select:
Not Act: ZONE 2 SPEAKERS L/R 
speaker terminals not 
activated (Powered Zone 2 
disabled).
Act:  ZONE 2 SPEAKERS L/R 
speaker terminals activated 
(Powered Zone 2 enabled).
6
Press the [SETUP] button.
Setup closes.