Rocketfish RF-RBWS02 User Manual
23
RF-RBKIT
2
At the same time (within 30 seconds), press and hold the button on
the receiver for over three seconds. The power-on indicator starts
blinking quickly. After a brief period both LEDs should turn solid,
indicating they successfully joined the network.
• The power-on indicator starts blinking fast.
• The power-on indicator will light solidly if the link is activated
between both the units.
• If the power-on indicator blinks at a slower rate, the link is not
successful.
Notes: If the power-on indicators of the sender and receiver blink slowly after
blinking quickly for 30 seconds, it means that there is no active link between the
sender and receiver. Try to connect the system as described above, using the
power-on buttons on both units. For more information, please see “Troubleshooting”.
sender and receiver. Try to connect the system as described above, using the
power-on buttons on both units. For more information, please see “Troubleshooting”.
New devices must be joined to the hub device, not to other devices in the network.
Therefore, when adding a new device to an existing network, you must put the device
with the Green LED (the Hub) in Join mode with the device you want to add to the
network.
Therefore, when adding a new device to an existing network, you must put the device
with the Green LED (the Hub) in Join mode with the device you want to add to the
network.
When connecting rear and surround channels, you can see which
device you are connecting to over the air by pressing the Source
button. The sender’s LED will blink for a few seconds, showing the
connection between the transmitter and receiver. This makes it easier
to configure rears and surrounds without relying on AVR test
patterns.
device you are connecting to over the air by pressing the Source
button. The sender’s LED will blink for a few seconds, showing the
connection between the transmitter and receiver. This makes it easier
to configure rears and surrounds without relying on AVR test
patterns.
Listening to the system
To listen to the system:
1
Make sure that the system is powered on and that there is an active link
between the sender and receiver.
2
Turn down the volume level on your audio source to a minimum, then
turn on and begin playing the audio source.
3
Press the SOURCE button on the receiver or the NEXT SOURCE button
on the remote control to select the audio source from A or B on the back
of the sender.
4
Adjust the volume level on your audio source or use the remote control.
Note: Switch your home theater system settings from stereo to surround mode or
completely turn off the stereo mode.
completely turn off the stereo mode.
RF-RBKIT_09-0473_MAN_ENG_V1.fm Page 23 Thursday, August 27, 2009 6:44 PM