Rocketfish RF-RBWS02 User Manual

RF-RBKIT

No communication 
between the sender 
and receiver

• Make sure that the AC adapter is connected to the sender and the power cord is connected to 

the receiver.

• Once the power-on buttons have been held to turn on both sender and receiver and both units 

are in joining mode, the power-on indicators should blink quickly.

• If the power-on indicators on both units are solidly on, then a communication link has been 

successfully established between the units. If the power indicators on both the units are 
blinking at a slower rate, press and hold the 

 buttons on either sender or receiver for three 

seconds. This will put the unit into joining mode for about 30 seconds. During this time, press 
the 

 button on the other unit for three seconds, so that it will also enter joining mode. The 

system proceeds with the connection process between the sender and receiver. During the 
joining mode, the power indicators on both sender and receiver blink at a faster rate. When an 
active link is established between the sender and receiver, the power-on indicators on both 
units are solid on and do not flash.

Note: Try pressing the   buttons again if the power indicators are blinking at a slower rate after 

blinking fast for 30 seconds.

No response when 
you press any button

• Try disconnecting the device from the power source to reset it.

Connecting a source 
device

• If your network is already full with transmitters when joining is attempted, the Source LED will 

blink three times and then turn off. Remove (power down) a transmitting device and try again.

Connecting a device

• When you try to join a device to a network that has too many nodes, the device will stay in 

joining mode until it times out (30 second timeout). Upon timeout the unit should be on and 
will flash the power ring LED in a slow blink indicating it is not connected to the network.

When trying to 
change the source on 
a Rocketfish unit the 
Power LED flashes 
five times.

• Your RF-RBKIT sender is in four channel lock mode. By design, these channels are not available 

for access by other receivers as they form the rears/surrounds of your Home Theater system. If 
you do wish to use them, then you should remove the four channel lock mode by moving the 
switch on the back of the sender to disable four channel lock mode. Both sources will then be 
available for all receivers.

30 V RMS

16-bit, 48 KHz uncompressed

DC 5 V at 0.6 A

15 - 20 ms

2 V RMS (Max. input)
1 V RMS (Standard input)

RF-RBKIT_09-0473_MAN_ENG_V1.fm  Page 31  Thursday, August 27, 2009  6:44 PM