Rocketfish RF-RBWS02 User Manual
32
Receiver
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply within the
limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
product is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply within the
limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Audio input - wireless
Stereo, 16-bit, 48 KHz, uncompressed.
System performance
Signal-to-noise ratio: 94dB (HD mode
>
96dB)
Total harmonic distortion: 1%
Audio output - high
efficiency. Class D,
speaker level
Support for 4 to 8 ohm speakers
Audio power output: 2 x 42 W (RMS) into 4 ohms
Audio power output: 2 x 42 W (RMS) into 4 ohms
Transmission delay
15 - 20 ms
Power supply
AC 120V~60 Hz
Power consumption
30 W
RF-RBKIT_09-0473_MAN_ENG_V1.fm Page 32 Thursday, August 27, 2009 6:44 PM