Sony DAV-DS1000 User Manual

GB

Do not install the appliance in a
confined space, such as a bookcase
or built-in cabinet.
To prevent fire, do not cover the
ventilation of the apparatus with
newspapers, table-cloths, curtains,
etc. And don’t place lighted candles
on the apparatus.
To prevent fire or shock hazard, do
not place objects filled with liquids,
such as vases, on the apparatus.

This appliance is classified as a
CLASS 1 LASER product. The label
is located on the bottom exterior of
the Control unit.

Don’t throw
away the battery
with general
house waste,
dipose of it
correctly as
chemical waste.

This symbol is intended to
alert the user to the
presence of uninsulated

“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.

This symbol is intended to
alert the user to the
presence of important

operating and
maintenance (servicing) instructions
in the literature accompanying the
appliance.

The model and serial numbers are
located on the bottom exterior of the
Control unit, on the rear exterior of
the Subwoofer, and on the baseplate
of each Wireless rear speaker.
Record the serial number in the
spaces provided below. Refer to
them whenever you call upon your
Sony dealer regarding this product.

System Model: DAV-DS1000
Component Models:
Model No.DVX-DS1000
(Control unit)
Serial No.______________
Model No.SA-WS1000
(Subwoofer)
Serial No.______________
Model No.SA-IR1000
(Wireless rear speakers)
Serial No.______________ &
______________

Use of this appliance with this some
systems may present a shock or fire
hazard. Do not use with any units
which have the following marking
located near output,
“WARNING! HAZARDOUS
ENERGY!...”
The use of optical instruments with
this product will increase eye
hazard.
As the laser  beam used in this CD/
DVD player is harmful to eyes, do
not attempt to disassemble the
cabinet. Refer servicing to qualified
personnel only.

This label is located at the rear of the
Control unit.

This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving

antenna.

- Increase the separation between

the equipment and receiver.

- Connect the equipment into an

outlet on a circuit different from
that to which the receiver is
connected.

- Consult the dealer or an

experienced radio/TV technician
for help.

You are cautioned that any changes
or modifications not expressly
approved in this manual could void
your authority to operate this
equipment.

The shielded interface cable
recommended in this manual must
be used with this equipment in order
to comply with The limits for a
digital device pursuant to Subpart 15
of FCC Rules.

This reminder is provided to call the
CATV system installer’s attention to
Article 820-40 of the NEC that
provides guidelines for proper
grounding and, in particular,
specifies that the cable ground shall
be connected to the grounding
system of the building, as close to
the point of cable entry as practical.