Sony DAV-DS1000 User Manual

GB

Do not turn up the volume while listening to a
section with very low level inputs or no audio
signals. If you do, the speakers may be damaged
when a peak level section is suddenly played.

Clean the cabinet, panel, and controls with a soft
cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad,
scouring powder or solvent such as alcohol or
benzine.
If you have any questions or problems concerning
your system, please consult your nearest Sony

dealer.

Do not use a commercially available CD/DVD
cleaning disc. It may cause a malfunction.

If the speakers should cause the TV screen to have
color irregularity, turn off the TV at once then
turn it on after 15 to 30 minutes. If color
irregularity should persist, place the speakers
further away from the set.

The nameplate is located on the bottom exterior
of the Control unit and the Tuner.

Caution: This system is capable of holding a
still video image or on-screen display image on
your television screen indefinitely. If you leave
the still video image or on-screen display image
displayed on your TV for an extended period of
time you risk permanent damage to your
television screen. Projection televisions are
especially susceptible to this.

When you carry the system, use the following
procedure to protect the inner mechanism.
Remove an inserted disc by pressing Z. After
removing the disc, press Z again to close the disc
shutter. Wait at least 10 seconds after the disc
shutter closes, and then turn off the system. If
more than 10 seconds have passed with no disc in
the system and the disc shutter closed, turn off the
system.

• Should any solid object or liquid fall into the

cabinet, unplug the system and have it checked
by qualified personnel before operating it any
further.

• Do not climb on the subwoofer, as you may fall

down and injure yourself, or system damage
may result.

AC power cord must be changed only at the
qualified service shop.

• Place the system in a location with adequate

ventilation to prevent heat build-up in the
system.

• At high volume, over long periods of time, the

cabinet becomes hot to the touch. This is not a
malfunction. However, touching the cabinet
should be avoided. Do not place the unit in a
confined space where ventilation is poor as this
may cause overheating.

• Do not block the ventilation slots by putting

anything on the system. The system is equipped
with a high power amplifier. If the ventilation
slots on the top surface are blocked, the unit can
overheat and malfunction.

• Do not place the system on a soft surface such

as a rug that might block the ventilation holes
on the bottom.

• Do not place the system in a location near heat

sources, or in a place subject to direct sunlight,
excessive dust, or mechanical shock.

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp
room, moisture may condense on the lenses
inside the system. Should this occur, the system
may not operate properly. In this case, remove
the disc and leave the system turned on for
about half an hour until the moisture evaporates.

• When you move the system, take out any discs.

If you do not, the disc may be damaged.

• For power saving purposes, the system can be

completely turned off by the ! button on the
subwoofer. Though the LED remains lit for a
while, the system is completely off.