Tascam SN29401376 User Manual

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use 
the tuner.

• Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible 

reception.

• Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.

• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
• If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM 

antenna.

Thumbtacks, etc.

Insert the plug fully 
into the jack.

Insert the plug fully 
into the jack.

Push.

Insert wire.

Release.

Indoor FM antenna (supplied)

AM loop antenna (supplied)

• Be careful not to injure yourself 

when using thumbtacks.

• Turning on the AV receiver may cause a momentary power surge 

that might interfere with other electrical equipment on the same 
circuit. If this is a problem, plug the AV receiver into a different 
branch circuit.

• Do not use a power cord other than the one supplied with the AV 

receiver. The supplied power cord is designed exclusively for use 
with the AV receiver and should not be used with any other 
equipment.

• Never disconnect the power cord from the AV receiver while the 

other end is still plugged into a wall outlet. Doing so may cause 
an electric shock. Always disconnect the power cord from the 
wall outlet first, and then the AV receiver.

To AC wall outlet