Tascam SN29401376 User Manual

■

`

Fixed: 

The Zone 2 volume must be set on the amp in that 
zone.

`

Variable:

The Zone 2 volume can be set on the AV receiver.

If you’ve connected your Zone 2 speakers to an amp with 
no volume control, set the “Zone 2 Out” setting, to 
“Variable” so that you can set the volume, balance, and 
tone of zone 2 on the AV receiver.

■

`

Off, 30 to 79

With this setting, you can limit the maximum volume for 
Zone 2.

■

`

Last, Min, 1 to 79 or Max

This setting determines what the volume will be for Zone 2 
each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was 
last turned off, select “Last”.
The “Zone 2 Power On Volume” cannot be set higher 
than the “Zone 2 Maximum Volume” setting.

■

`

10kHz/200kHz:

`

9kHz/50kHz:

Select the frequency step according to your area.

■

`

10kHz:

`

9kHz:

Select the frequency step according to your area.

For AM/FM tuning to work properly, you must specify the 
AM/FM frequency step used in your area. 

• When this setting is changed, all radio presets will be deleted.

■

`

Off 

`

Turn this setting on to allow 

p

-compatible 

components connected via HDMI to be controlled by the 
AV receiver (

➔ page 86).

• When the setting is set to “On” and the menu is closed, the names 

of connected 

p-compatible components and “RIHD On” 

are displayed on the AV receiver.
“Search…” 

→ “(name)” → “RIHD On”

When the AV receiver cannot receive the name of the component, 
it is displayed as “Player

” or “Recorder

”, etc. (“

” shows up 

and indicates the number of components, when two or more are 
received).

• When an 

p-compatible component is connected to the 

AV receiver via an HDMI cable, the name of the connected 
component is displayed on the AV receiver’s display. For 
example, while you are watching TV broadcasting, if you operate 
a Blu-ray Disc/DVD player (being powered on) with the remote 
control of the AV receiver, the name of the Blu-ray Disc/DVD 
player will be displayed on the AV receiver.

• Set it to 

“

”

 when a connected piece of equipment is not 

compatible or it is unclear whether the equipment is compatible 
or not.

• If operation is not normal when set to 

“

”

, change the setting to 

“

”

.

• Refer to the connected component’s instruction manual for 

details.

• When the “HDMI Control(RIHD)” setting is set to “On”, the 

power consumption on standby mode slightly increases. 
(Depending on the TV status, the AV receiver will enter standby 
mode as usual.)

• When the source equipment is connected with the 

u 

connection, it may malfunction if “HDMI Control(RIHD)” is 
set to “On”.

“Setup”