Vivitek DU6675 User Manual

DU6675 DLP Projector - User's Manual

46

This function is set to OFF by default. When it is set to ON and no input signal is received 

within 20 minutes, the projector will turn off automatically.

This function is set to OFF by default. When it is set to ON, the projector will turn on 

automatically when you connect it to an AC power source next time. You can use this 

function and the power switch (instead of the remote control) to turn on the projector. Set 

this function to OFF if you do not need to use it.

Baud Rate: Set the transmission rate to 38400, 19200, 9600. The setting of the 

transmission rate is dependent on the length of the RS-232 cable. Low transmission rate 

is usually set for long transmission cables. If RS-232 is used to control the projector, the 

signal is unstable or no communication is connected, select a suitable transmission rate.

Channel: The RS232 control command can be sent to the projector through its RS-

232 port, the command can also be sent to the projector through the external HDBaseT 

transmitter to HDBaseT/LAN terminal of the projector. Set the following communication 

channels before sending the control command.

Local: The RS-232 control command is sent through the RS-232 port on the projector. 

Select an appropriate baud rate.

HDBaseT: Transmission is conducted from the external HDBaseT transmitter to the RJ-

45 port on the projector. The baud rate is switched to 9600.

Use this function to set up network configurations so that you can control the projector via 

the network.

Press ▲▼ and the Enter button to select Network and network settings:

IP Address: To specify an IP address, press the Enter button to show the IP address 

input window. Use the ◄► button to select the number in the address to be changed. 

Use the ▲▼ button to increase or decrease the number in the IP address.