Viper FANG 18C User Manual

 

 

 

                         

 
1.  Adjust control housing to a comfortable operating height by squeezing together the two thumb 

levers directly underneath the housing.   

2.  Lower squeegee assembly to the floor. 
3.  Turn brush motor switch to “on” position.   
4.  Turn vacuum motor switch to “on” position. 
5.  Rotate the ball valve of solution tank to horizontal position. Solution will not begin to flow until the 

operating triggers are pulled.   

6.  To begin scrubbing, pull on one or both of the red operating triggers, when these triggers are 

pulled, the brush will begin to spin and the solution will begin to flow.   

7.  Begin scrubbing by moving the machine forward. 
8.  Adjust solution flow by adjusting the position of ball valve knob. 

1.  Occasionally look through the clear recovery tank lid to see if there is any foam build-up.  If 

excessive foam is found, add defoamer to the recovery tank. 

2.  Occasionally view the clear tube at the back left of the machine to check the amount of cleaning 

solution that is left in the machine. 

3.  If the squeegee assembly leaves streaks on the floor, raise the squeegee off the floor and wipe 

the blades down with a damp cloth. 

4.  When the solution tank runs empty, turn off the brush switch and ball valve of solution tank.  

Keep the squeegee down and continue to vacuum until all the dirty water is picked up.   

 

                Warning! 

 

              Warning! 

                   

               

 

             

 

 

 

 

 

80188EU(1)2009-01