Nilfisk Alto R 580 B User Manual

FLOORTEC R 580 B

146 2601 000(1)2005-03 A

7.

Press both the enabling switch (1, Fig. B) and the 
hopper lowering switch (15) to lower the hopper down 
to the desired position.

8.

The machine is ready to start working again.

After working, before leaving the machine:
–

Lift the main broom with the lever (24, Fig. B).

–

Lift the side brooms with the levers (21 and 22, Fig. 
B).

–

Close the suction by means of the related lever (17, 
Fig. B), then press the filter-shaker switch (14, Fig. B) 
for a short interval; open the suction again.

–

Dump the hopper (4, Fig. C) (see previous 
paragraph).

–

Remove the ignition key from the switch (18, Fig. B).

–

Engage the parking brake by pressing the brake 
pedal (26, Fig. B), then activate the brake lock control 
lever (19).

If necessary, adjust the working light (9, Fig. C) beam 
aiming with the screws (22).

If you foresee that the machine will not be used for more 
than 30 days, proceed as follows:
–

Check that the machine storage area is dry and 
clean.

–

Disconnect the battery connector (4, Fig. V).

After the first period of use (first 8 hours) it is necessary to 
check that the fixing and connecting elements are 
correctly tightened, that the visible parts are integral and 
that there are no leakages.

The lifespan of the machine and its maximum operating 
safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. 
The intervals shown may vary according to particular 
working conditions, which are to be defined by the person 
in charge of the maintenance.

All scheduled or extraordinary maintenance operations 
must be performed by qualified personnel, or by an 
authorised Service Center. 
This manual describes only the easier and most common 
maintenance procedures.

NOTE