Nilfisk Alto 30 M User Manual

26

ATTIX 30/50 H/M

english

*) 

Optional accessories / Option depending on model

‡ Motor does not start

> Fuse of the mains socket has 

blown.

• Connect mains fuse.

> Overload protection switch 

has tripped.

• Switch off the vacuum cleaner 

and allow it to cool for approx. 
5 minutes. If the cleaner 
cannot be started again, 
contact the Nilfisk-Alto service 
department.

> Motor is faulty.

• Have motor changed by 

Nilfisk-Alto Service.

‡

Motor does not run in 
automatic mode 

*)

> Power tool/pneumatic tool is 

defective or not connected 
properly.

• Check that the power tool 

works or that the plug is 
inserted correctly.

> The power rating of the 

electrical tool is too low.

• Note that minimum power 

rating is P>40W

‡

The acoustic warning 
sounds. (Reduced suction 
power)

> Suction power selected with 

suction power control

*)

 is too 

low.

• Set suction power in 

accordance with section 
„Setting suction power“.

> Hose diameter does not 

correspond with switch 
position

• Set correct switch position for 

hose diameter

> Clogged suction hose/nozzle. • Clean suction hose/nozzle
> Tank, disposal bag or filter 

bag is full.

• See "Emptying tank" or 

"Replacing disposal bag, filter 
bag" sections.

> Filter element is clogged.

• See section „Cleaning filter 

element“ and „Replacing filter 
element“.

> Seal between tank and upper 

section of vacuum cleaner is 
faulty or missing.

• Replace seal.

> Cleaning mechanism is 

defective.

• Contact Nilfisk-Alto Service.

‡

No suction power during 
wet cleaning 

> Tank is full. 

• Switch off the cleaner. Empty 

the tank.

‡

Voltage fluctuations

> Impedance of power supply is 

too high.

• Connect the cleaner to another 

socket  closer  to  the  fuse  box. 
Voltage 

fluctuations 

over 

7%  should  not  occur  if  the 
impedance at the transfer point 
is ≤ 0.15 Ω .