Emerson 5081-P User Manual
4
1.4 TRANSMITTER DISPLAy DURING
CALIBRATION AND PROGRAMMING
(FIGURE 1-1)
CALIBRATION AND PROGRAMMING
(FIGURE 1-1)
1. Continuous display of pH, ORP, conductivity,
oxygen, chlorine, or ozone reading.
2. units: pH, mV, µS/cm, mS/cm, ppm, ppb,
% saturation, or %.
3. Current menu section appears here.
4. Submenus, prompts, and diagnostic readings
appear hear.
5. Commands available in each submenu or at
each prompt appear here.
6. Hold appears when the transmitter is in hold.
7. Fault appears when the transmitter detects a
sensor or instrument fault.
8.
©
flashes during HART digital communication.
1.5 INFRARED REMOTE CONTROLLER
(FIGURE 1-2)
(FIGURE 1-2)
1. Pressing a menu key allows the user access to
calibrate, program, or diagnostic menus.
2. Press ENTER to store data and settings. Press
NEXT to move from one submenu to the next.
Press EXIT to leave without storing changes.
Press EXIT to leave without storing changes.
3. use the editing arrow keys to scroll through lists
of allowed settings or to change a numerical set-
ting to the desired value.
ting to the desired value.
4. Pressing HOLd puts the transmitter in hold and
sends the output current to a pre-programmed
value. Pressing RESET causes the transmitter
to abandon the present menu operation and
return to the main display.
value. Pressing RESET causes the transmitter
to abandon the present menu operation and
return to the main display.
FIGURE 1-2. INFRARED REMOTE CONTROLLER
1.
4.
3.
2.
FIGURE 1-1. TRANSMITTER DISPLAy DURING
CALIBRATION AND PROGRAMMING
The program display screen allows access to calibration and
programming menus.
MODEL 5081-P pH/ORP
SECTION 1.0
DESCRIPTION AND SPECIFICATIONS