Brother S-7200C User Manual

 

 

S-7200C

 

121 

１０

-９. Adjusting the feed dog angle 

The standard angle for the feed dog (1) when it is at its 
highest position above the needle plate is when the “ ” mark 
(or V groove) on the shaft (2) is aligned with the feed rocker 
bracket arm (3). 
1. Turn the machine pulley to move the feed dog (1) to its 

highest position above the needle plate. 

2.  Tilt back the machine head. 
3.  Loosen the two set screws (4). 
4. Turn the shaft (2) in the direction of the arrow within a 

range of 90° with respect to the standard position. (Fig. 
[C]) 

・ 

In order to prevent puckering, lower the front of the 
feed dog (1). 

・ 

In order to prevent the material from slipping, raise the 
front of the feed dog (1). 

5.  Securely tighten the set screws (4). 

*  If you would like to tilt the feed dog (1) further, turn the 

feed lifting rock bracket stud (5) while carrying out the 
above adjustment. (Fig. [D]) 
(Refer to “10-8. Adjusting the feed dog height” on the 
previous page for details of this operation.) 

*  The height of the feed dog (1) will change after the angle 

has been adjusted, so it will be necessary to re-adjust the 
height of the feed dog (1). 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 

4255M 

2285M 

2284M 

Lower 
the front 

Raise the front 

Standard 

Lower the front 

Raise the front 

Parallel 

Needle 
plate 

Standard 

Lower the front 

Raise the front 

Standard 

Back is raised 

Back is lowered