Sony CDX-S2050V User Manual

Page of 80
12
CDX-S2050V/S2050C/S2050
2-348-403-21 (1)
H:\Data Disk\2348403211\234840321CDXS2050VEUR\01GB02CD-EUR.fm
masterpage:Left
• Before playing, clean the 
discs with a commercially 
available cleaning cloth. Wipe 
each disc from the centre out. 
Do not use solvents such as 
benzine, thinner, 
commercially available 
cleaners, or antistatic spray 
intended for analogue discs.
Notes on CD-R/CD-RW discs
• Some CD-Rs/CD-RWs (depending on the 
equipment used for its recording or the 
condition of the disc) may not play on this unit.
• You cannot play a CD-R/a CD-RW that is not 
finalized.
If you have any questions or problems 
concerning your unit that are not covered in this 
manual, consult your nearest Sony dealer.
Maintenance
Fuse replacement
When replacing the fuse, be 
sure to use one matching the 
amperage rating stated on the 
original fuse. If the fuse 
blows, check the power 
connection and replace the 
fuse. If the fuse blows again 
after replacement, there may 
be an internal malfunction. In 
such a case, consult your 
nearest Sony dealer.
Cleaning the connectors
The unit may not function properly if the 
connectors between the unit and the front panel 
are not clean. In order to prevent this, detach the 
front panel (page 4) and clean the connectors 
with a cotton swab dipped in alcohol. Do not 
apply too much force. Otherwise, the connectors 
may be damaged.
Notes
• For safety, turn off the ignition before cleaning the 
connectors, and remove the key from the ignition 
switch.
• Never touch the connectors directly with your fingers 
or with any metal device.
Removing the unit
1
Remove the protection collar.
1
Detach the front panel (page 4).
2
Engage the release keys together with the 
protection collar.
3
Pull out the release keys to remove the 
protection collar.
2
Remove the unit.
1
Insert both release keys simultaneously 
until they click.
2
Pull the release keys to unseat the unit.
3
Slide the unit out of the mounting.
Fuse (10A)
Main unit
Back of the front panel
Orient the release 
keys as shown.
Hook facing 
inwards.