Sony CDX-CA760X Manual

E:\DATA\01_18\876173S CDX-CA760X
(U)\3228169111\322816911CDXCA750U\01US02CD-U.fm

masterpage:Right

CDX-CA760X/CA750X

3-228-169-11(1)

Adjusting the sound
characteristics

You can adjust the bass, treble, balance, fader,
and subwoofer volume.
The bass and treble levels and subwoofer volume
can be stored independently for each source.

Select the item you want to adjust by
pressing

(SOUND)

repeatedly.

Each time you press (SOUND), the item
changes as follows:

BAS (bass)

TRE (treble)

BAL (left-right)

FAD (front-rear)

SUB (subwoofer volume)

Adjust the selected item by pressing
either side of

(SEEK)

When adjusting with the rotary commander,
press (SOUND) and rotate the VOL control.

Note
Adjust within 3 seconds after selecting the item.

Quickly attenuating the
sound

(With the rotary commander or the card
remote commander)

Press

(ATT)

on the rotary commander

or card remote commander.

“ATT on” appears in the display momentarily.

To restore the previous volume level, press
(ATT) again.

Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).

Changing the sound and
display settings

— Menu

The following items can be set:

Set Up

• Clock (page 9)
• Beep — to turn the beeps on or off.
• RM (Rotary Commander) — to change the

operative direction of the controls of the rotary
commander.
– Select “norm” to use the rotary commander

as the factory-set position.

– Select “rev” when you mount the rotary

commander on the right side of the steering
column.

• Multi language (language selection) — to

change the display language to English,
French, or Spanish.

• P.Out 4.0V/5.5V— to change the pre-out of the

power amplifier to 4.0V or 5.5V. Selectable
only when the unit is turned off. (CDX-
CA760X only)

Note
If the volume is turned up very high when connected
to a power amplifier, the sound may be distorted. In
this case, set P.Out to “4.0V.”

Display

• D.Info (Dual Information) — to display the

clock and the play mode at the same time (on).
Functions only when SA is not set to B-1 – B-5.

• SA (Spectrum Analyzer) (page 20) — to

change the display pattern of the equalizer
display.

• M.Dspl (Motion Display) — to select the

Motion Display mode from “1,” “2,” and “off.”
– Select “1” to show decoration patterns in the

display and activate Demo display.

– Select “2” to show decoration patterns in the

display and deactivate Demo display.

– Select “off” to deactivate the Motion Display.
The Demo display in the M.Dspl 1 mode will
appear about 10 seconds after the unit is turned
off.

• Dimmer — to change the brightness of the

display.
– Select “Auto” to dim the display only when

you turn the lights on.

– Select “on” to dim the display.
– Select “off” to deactivate the Dimmer.

• Contrast — to adjust the contrast if the

indications on the display are not recognizable
because of the unit’s installation position.