Petsafe PAC00-12893 User Manual

 www.petsafe.net 7

1. Lift the rubber dust cover protecting the Handheld 

Transmitter Charging Jack.

2. Connect one of the charger connectors to the 

Handheld Transmitter Charging Jack (

1A).

3. Plug the charger into a standard wall outlet. The 

Red LED will light up. When fully charged, the 

LED will change to Green. 

4. When charging is complete, be sure to replace 

the rubber dust cover.

40 to 60 hours, depending on frequency of use.
The Transmitter has two LED’s used to indicate 

the selected dog. The Dog 1 Red LED is on the 

left when holding the unit with the LED’s facing the 

operator, and the Dog 2 Green LED is on the right. 

The transmitter is factory set in single dog mode. To verify, press and release the Dog 

Select Button multiple times. (The Red LED will blink once for each press and release.)

Normal Operation

OFF

Low Battery - press and release any 

blue correction button

3 flashes every 5 seconds

Dog 1—any blue correction button

ON length of any blue correction button 

press. If a Static Stimulation button 

is held up to 12 continuous seconds, 

then a rapid flash will indicate a safety 

time-out.

Charging

ON

Normal Operation

OFF

Dog 2—any blue correction button

ON length of any blue correction button 

press. If a Static Stimulation button 

is held up to 12 continuous seconds, 

then a rapid flash will indicate a safety 

time-out.

Charging Complete

ON

1