Petsafe PAC00-12893 User Manual

8 

1. Lift the rubber dust cover protecting the Receiver 

Collar Charging Jack. 

2. Connect one of the charger connectors to the 

Receiver Collar Charging Jack (

2A).

3. Plug the charger into a standard wall outlet. The 

Red LED will light up. When fully charged, the LED 

will change to Green.

4. When charging is complete, be sure to replace the 

rubber dust cover.

1. Press and hold the On/Off Button (

2B) until 

the Green LED light comes on. (This takes 

approximately one second.) 

2. Release the On/Off Button.
In normal mode, the Green LED will flash once every 5 

seconds, indicating the Receiver Collar is on and ready 

to receive a radio signal from the Handheld Transmitter. 

1. When you press the On/Off Button, the Red LED 

light will come on. Hold down the button until the 

Red LED turns off (approximately 5 seconds).

On/Off Button

2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar off when it is not in use. 

Approximate battery life between charges is 15-20 hours, depending on frequency of use. 

Normal Operation - Low Battery

3 flashes every 5 seconds

Correction

ON while delivering correction

Charging

ON

Pairing Mode

Flashes once every second

Normal Operation - Good Battery

Flashes once every 5 seconds

Charging Complete

ON

2