Yamaha RX-SL100RDS User Manual
TROUBLESHOOTING
51
English
ADDITIONAL
INFO
RMA
T
IO
N
N
Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, unplug the power cord from the outlet, and
contact the nearest authorized YAMAHA dealer or service center.
or if the instruction below does not help, set this unit to the standby mode, unplug the power cord from the outlet, and
contact the nearest authorized YAMAHA dealer or service center.
■
General
TROUBLESHOOTING
Problem
Cause
Remedy
Refer to
page
This unit fails to turn
on when STANDBY/
ON is pressed, or
enters in the standby
mode soon after the
power has been
turned on.
on when STANDBY/
ON is pressed, or
enters in the standby
mode soon after the
power has been
turned on.
The power cord is not connected or the
plug is not completely inserted.
plug is not completely inserted.
Connect the power cord firmly.
—
The impedance setting is incorrect.
Set the impedance to match your speakers.
The protection circuitry has been
activated.
activated.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
external electric shock (such as lightning
and strong static electricity).
Set this unit in the standby mode, disconnect the
power cord, plug it back in after 30 seconds, then use
it normally.
power cord, plug it back in after 30 seconds, then use
it normally.
—
No sound
Incorrect input or output cable
connections.
connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
the cables may be defective.
Input Mode is set to dts or Analog.
Select AUTO.
No appropriate input source has been
selected.
selected.
Select an appropriate input source by pressing
INPUT, then rotating VOLUME/SELECT or using
the input selector buttons.
INPUT, then rotating VOLUME/SELECT or using
the input selector buttons.
Speaker connections are not secure.
Secure the connections.
The volume is turned down.
Turn up the volume.
—
The sound is muted.
Press MUTE or any operation button on this unit to
cancel mute and adjust the volume.
cancel mute and adjust the volume.
If you are playing an LD source, the
player may not output digital signals if the
LD source was not digitally recorded.
player may not output digital signals if the
LD source was not digitally recorded.
Set the Input Mode to Analog.
The Input Mode is set to Analog while
playing a source encoded with a DTS
signal.
playing a source encoded with a DTS
signal.
Set the Input Mode to AUTO or dts.
Signals this unit cannot reproduce are
being received from a source component
e.g.: a CD-ROM.
being received from a source component
e.g.: a CD-ROM.
Play a source whose signals this unit can reproduce.
—
01EN.00_RX-SL100RDS.book Page 51 Thursday, November 27, 2003 12:42 PM