Yamaha RX-A2010 User Manual

En

Optimizes the speaker settings automatically (YPAO).

Registers two speaker setting patterns and switches between them.

Copies the “Setting Pattern” parameters in the specified direction.

Selects a speaker system.

Selects the size of the front speakers.

Selects whether or not a center speaker is connected and its size.

Selects whether or not surround speakers are connected and its size.

Selects whether or not surround back speakers are connected and its size.

Selects whether or not front presence speakers are connected.

Selects whether or not to rear presence speakers are connected.

Selects whether or not a subwoofer is connected to the SUBWOOFER 1 or SUBWOOFER 2 jack and its phase.

Selects a subwoofer layout when 2 subwoofers are used.

Sets the speakers to produce the front channel low-frequency components.

Sets the distance between each speaker and listening position.

Adjusts the volume of each speaker.

Selects a type of equalizer to be used.

Copies the parametric equalizer values acquired with “Auto Setup” to the “Manual” fields for fine adjustment.

Enables/disabled the test tone output.

Adjusts the delay between video and audio output. 

Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.

Sets the maximum volume so that sound is not too loud.

Sets the initial volume for when this receiver is turned on.

Selects whether to output video signals during the Pure Direct mode.

Selects whether to automatically adjust the CINEMA DSP effect level in conjunction with volume adjustments.

Enables/disables the video conversion between the analog video jacks.

Enables/disables the video signal processing (resolution, aspect ratio and video adjustments).

Enables/disables HDMI Control. You can also configure the relevant settings (ARC, TV audio input, etc).

Selects a device to output audio.

Select whether to output videos/audio (input through HDMI jacks) to the TV when this unit is in standby mode.