Yamaha RX-A2010 User Manual

En

The playback device is set to output 2-channel audio (PCM, etc.) 
only.

Change the digital audio output setting on the playback device.

This unit is too close to other digital or radio frequency device.

Move this unit further away from such device.

The cable connecting this unit and playback device is defective.

If there is no problem with the connection, replace with another cable.

Any device connected to the output jacks of this unit is not turned 
on. (This may happen due to the nature of AV receivers.)

Turn on all devices connected to the output jacks of this unit

Another input source is selected on this unit.

Select an appropriate input source with the input selection keys

Another input source is selected on the TV.

Switch the TV input to display the video from this unit.

The video signal output from this unit is not supported by the TV.

Set “MONITOR CHECK” in the “ADVANCED SETUP” menu to “YES” (p.126).

The cable connecting this unit and TV (or playback device) is 
defective.

If there is no problem with the connection, replace with another cable.

The input video signal (resolution) is not supported by this unit.

To check the information about the current video signal (resolution), use “Video 
Signal” in the “Information” menu (p.123). For information about video signals 
supported by this unit, see “HDMI signal compatibility” (p.151).

The TV does not support HDCP (High-bandwidth Digital Content 
Protection).

To check it, use “Video Signal” in the “Information” menu (p.123).

The number of devices connected to the HDMI OUT jack is over 
the limit.

Disconnect some of the HDMI devices.