Yamaha RX-A2010 User Manual
En
143
Remote control
This unit does not detect the PC.
The media sharing setting is not correct.
Configure the sharing setting and select this unit as a device to which music
contents are shared (p.80).
contents are shared (p.80).
Some security software installed on your PC is blocking the access
of this unit to your PC.
of this unit to your PC.
Check the settings of security software installed on your PC.
This unit and PC are not in the same network.
Check the network connections and the settings of your router to connect them to
the same network.
the same network.
The files in the PC cannot be viewed or
played back.
played back.
The files are not supported by this unit or the media server.
Use the file format supported by both this unit and the media server. For
information about the file formats supported by this unit, see “Playing back music
stored on PCs” (p.80).
information about the file formats supported by this unit, see “Playing back music
stored on PCs” (p.80).
The Internet radio cannot be played.
The selected Internet radio station is currently not available.
It may not be available to listen because there might be a network problem, or the
station might be broadcasting in limited hour. Try the station later or select another
station.
station might be broadcasting in limited hour. Try the station later or select another
station.
The selected Internet radio station broadcasts audio silence
currently.
currently.
Some Internet radio stations broadcast audio silence during particular periods of
time in a day. Try the station later or select another station.
time in a day. Try the station later or select another station.
Access to the network is restricted by the firewall settings of your
network devices (router, etc).
network devices (router, etc).
Check the firewall settings of your network devices. The Internet radio can be
played only when it passes through the port designated by each radio station.
The port number is variable depending on radio station.
played only when it passes through the port designated by each radio station.
The port number is variable depending on radio station.
Problem
Cause
Remedy
This unit cannot be controlled using the
remote control.
remote control.
Out of the operating range.
Use the remote control in the operating range (p.5).
The batteries are weak.
Replace with new batteries.
Direct sunlight or lighting is striking the remote control sensor of
this unit.
this unit.
Adjust the lighting angle, or reposition this unit.
The remote control is set to control external devices.
Press SOURCE/RECEIVER to set the remote control to control this unit (the key
lights up in orange).
lights up in orange).
The remote control IDs of the main unit and remote control are not
identical.
identical.
Change the remote control ID of the main unit or remote control (p.125).
External devices cannot be controlled
using the remote control.
using the remote control.
The remote control is set to control this unit.
Press SOURCE/RECEIVER to set the remote control to control external devices
(the key lights up in green).
(the key lights up in green).
The corresponding remote control code is not set properly.
Set the remote control code again (p.128). Even if the remote control code is
registered properly set, some products may not respond to the remote control.
registered properly set, some products may not respond to the remote control.
The remote control does not learn new
functions.
functions.
The batteries of the remote control of this unit and/or the external
device are weak.
device are weak.
Replace with new batteries.
The distance between the two remote controls is not appropriate.
Place the remote controls at a proper distance (p.130).
The signal coding or modulation of the other remote control is not
compatible with this remote control.
compatible with this remote control.
Learning is impossible in this case.
Memory capacity is full.
Clear unnecessary assignments to free some memory space for the new
functions (p.134).
functions (p.134).
Problem
Cause
Remedy