Yamaha RX-Z7 User Manual

■ Control Monitor (Control monitor)

Use this feature to select the HDMI OUT jack at which 
HDMI control signals are output.

■ Monitor Info. (Monitor information)

Use this feature to check the information (interface and 
frequency for each video resolution) about the video 
monitors connected to the HDMI OUT 1 and HDMI OUT 
2 jacks of this unit.

y

Press 9h repeatedly to toggle between “OUT1” (information 
about the video monitor connected to the HDMI OUT 1 jack) 
and “OUT2” (information about the video monitor connected to 
the HDMI OUT 2 jack).

Use this menu to adjust the network parameters.

In case you changed your network configuration, you may 
need to reconfigure the network settings.

y

You can reset the all parameters in “Network” to the initial 
factory settings by using “NETWORK” of “INITIALIZE” in 
“ADVANCED SETUP” (page 131).

■ Configuration (Network configurations)

Use this feature to view the network parameters (IP 
address, etc.) or to change them manually.

DHCP (DHCP setting)
Use this feature to select whether this unit can obtain the 
network parameters (IP address, subnet mask, default 
gateway, primary DNS server and secondary DNS server) 
from the DHCP server of the connected network.

IP Address (IP address)
Use this parameter to specify an IP address assigned to 
this unit. This value must not duplicate the one used for 
other devices in the target network.

Subnet Mask (Subnet mask)
Use this parameter to specify the subnet mask value 
assigned to this unit.

y

For most of the cases, the subnet mask value can be set as 
“255.255.255.0”.

Default Gateway (Default gateway)
Use this parameter to specify the IP address of the default 
gateway.

DNS Server (S) (Secondary DNS server)
Use this parameter to specify the IP address of the primary 
and secondary DNS (Domain Name System) servers.

If you have only one DNS address, enter the DNS address in 
“DNS Server (P)”. If you have two or more DNS addresses, 
enter one of them in “DNS Server (P)” and another in “DNS 
Server (S)”.

■ Network Standby (Network standby)

Use this feature to select whether this unit accepts the 
commands via LAN network when this unit is in the 
standby mode.

When “Network Standby” is set to “On”, the amount of power 
consumption in the standby mode increases.

■ Information (Network information)

Use this feature to display the network system 
information.

MAC Address 
(MAC (Media Access Control) address)
This information displays the MAC address that is 
assigned to this unit.

Status (Network status)
This information displays the current link status of the 
network.
Display status: 10BASE-T, 100BASE-TX, No Link, 

Full Duplex, Half Duplex

“No Link” appears when network connection is not made.

System (System ID)
This information displays the system ID that is assigned to 
this unit.

Outputs HDMI control signals at the HDMI 
OUT 1 jack.

HDMI OUT2

Outputs HDMI control signals at the HDMI 
OUT 2 jack.

Select this setting when this unit can obtain the 
network parameters from the DHCP server of 
the connected network.

Off

Select this setting when you set the network 
parameters manually.

Does not accept the operations via LAN 
network when this unit is in the standby mode.

On

Accepts the operations via LAN network when 
this unit is in the standby mode.