Yamaha RX-Z7 User Manual

You can select the zone you want to control by using the 
control buttons on the front panel or on the remote control. 

While Zone 4 is turned on, no signal is output at the DVR OUT, 
VCR OUT and MD/CD-R OUT jacks.

■ Basic operation

Press O

ZONE 2, OZONE 3 or OZONE 4 

Press O

ZONE CONTROLS on the front 

Each time you press OZONE CONTROLS, the 
front panel display changes as shown below, and the 
indicator for the currently selected zone flashes for 
approximately 10 seconds. However, no indicator 
flashes when the main zone is selected.

ZONE2
Controls the Zone 2 amplifier or tuner functions.

ZONE3
Controls the Zone 3 amplifier or tuner functions.

ZONE4
Controls the Zone 4 amplifier and tuner functions

y

You must complete this step within 10 seconds while the 
selected zone flashes in the front panel display. Otherwise, 
the currently selected zone mode is automatically 
canceled.

y

To turn off the desired zone, press 

OZONE2, OZONE3 

or 

OZONE4 again.

Press H

ZONE repeatedly to select the zone 

you want to control.
“MAIN”, “ZONE2”, “ZONE3” or “ZONE4” 
indicator appears in the display window (D) on the 
remote control.

Press E

POWER to turn on the selected 

y

To turn off the desired zone, press DSTANDBY.

■ Selecting the input source of Zone 2, 

L

INPUT selector (or set the 

operation mode selector to F

AMP and then 

press one of the input selector buttons (3)).

• Select “TUNER” as the input source to use the FM/AM 

tuning features (page 56) in the selected zone.

• Select “XM” as the input source to use the XM 

Satellite Radio features (page 61) in the selected zone.

• Select “SIRIUS” as the input source to use the SIRIUS 

Satellite Radio features (page 65) in the selected zone.

• Select “DOCK” as the input source to use the iPod 

features (page 73) or Bluetooth features (page 71) in 
the selected zone.

• Select “USB/NET” as the input source to use the USB 

features (page 76) or network features (page 76) in the 
selected zone.

The input sources are shared across all zones.

■ Adjusting the volume level of Zone 2 or 

Rotate P

VOLUME (or press JVOLUME +/–).

y

Press LMUTE on the remote control to mute the sound output 
to the selected zone.

After the connections, turn on this unit and set the 
speaker terminal assignments with “Zone SP Assign” 
(page 103).