Yamaha RX-Z7 User Manual

y

It is recommended that you use a tripod (etc.) to affix the 
optimizer microphone at the same height as your ears 
would be when you are seated in your listening position. 
You can use the attached screw of a tripod (etc.) to fix the 
optimizer microphone to the tripod (etc.).

Press 9

ENTER to start the measurement.

This unit starts to count down from 10 seconds.

y

• To start the measurement immediately, press 9ENTER 

again.

• To cancel the automatic setup and return to the previous 

screen, press ?RETURN and then 9ENTER.

Loud test tones are output from each speaker during 
the measurement. Once all items are measured, 
“COMPLETED” appears.

If an error or warning message appears, see “Automatic 
setup” (page 145).

y

You can check the results of the measurements by using 
the GUI screen (page 40).

Use this feature to optimize the setup of this unit for one 
listening position. You can also select the parameters to be 
optimized in the automatic setup.

Turn on the video monitor and then follow 
steps 1 and 2 in “Quick automatic setup” 
(page 35).

Press I

MENU on the remote control.

The following screen (GUI menu) appears in the 
video monitor.

To select the parameters to be optimized, 
press 9k to select “Setup Menu” and then 
press 9h.
When you do not need to select the parameters to be 
optimized, skip to step 6.

y

If you do not select the parameters to be optimized, this 
unit will optimize the parameters you selected last time. 
All the parameters except “Angle” are selected by the 
initial factory settings.

Press 9k / n repeatedly to select the 
parameter and then press 9

ENTER to 

check or uncheck the box.
Check the boxes for the parameters to be optimized.

Once you perform the next operation, this unit starts the 
automatic setup procedure in 10 seconds. During the automatic 
setup procedure, do not perform any operation on this unit. For 
more accurate measurements, we recommended that you get out 
of the room or move to the wall where speakers are not around 
during the measurement. It takes approximately 3 minutes.

C O M P L E T E D

P L S U N P L U G M I C

E R R O R : E - 0 1

P R E S S E N T E R

Multi Measure 
(Multiple point 
measurement)

You can optimize the setup of this unit for 
multiple listening positions. For details, see 
“Advanced automatic setup” (page 38). In 
the basic automatic setup, leave this setting 
to the default.

Wiring 
(Speaker wiring)

This unit checks and adjusts which speakers 
are connected and the polarity of each 
speaker.

Distance 
(Speaker distance)

This unit checks and adjusts the distance of 
each speaker from the listening position and 
adjusts the timing of each channel.

Size 
(Speaker size)

This unit checks and adjusts the frequency 
response of each speaker and sets the 
appropriate low-frequency crossover for 
each channel.