Yamaha RX-Z7 User Manual

If you have finished the settings, press 9l 
to return to the previous menu level and then 
press 9n to select “Start”.

Press 9

ENTER to start the measurement.

This unit starts to count down from 10 seconds.

y

• To start the measurement immediately, press 9ENTER 

again.

• To cancel the automatic setup and return to the previous 

screen, press ?RETURN and then 9ENTER.

Loud test tones are output from each speaker during 
the measurement.
If you have selected “Angle” in step 4, the following 
screen appears. Proceed to step 7.

If you have not selected “Angle” in step 4, 
“Measurement Completed Successful” appears once 
all items are measured. Skip to step 11.

If an error or warning message appears, see “Error and 
warning messages” (page 38).

Place the supplied microphone base at the 
position you will be seated most frequently.
Make sure that the arrow on the microphone base 
points the center speaker or about the midpoint 
between the front left and right speakers.

It is recommended that you use a tripod (etc.) to affix the 
microphone base at the same height as your ears would be 
when you are seated in your listening position. You can 
use the attached screw of a tripod (etc.) to fix the 
microphone base to the tripod (etc.).

Place the optimizer microphone to the 
position “1” on the microphone base and 
then press 9

ENTER.

This unit starts the measurement of the speaker 
angles.

Move the optimizer microphone to the 
position “2”on the microphone base and 
then press 9

ENTER.

Equalizing 
(Speaker 
equalizing)

Parametric equalizer adjusts the level of the 
specified frequency bands. This unit 
automatically selects the crucial frequency 
bands for the listening room and adjusts the 
level of the selected frequency bands to 
create a cohesive sound field in the room.

Level 
(Speaker level)

This unit checks and adjusts the volume 
level of each speaker.

Angle 
(Speaker angle)

Checks the angles of the front speakers, 
surround speakers, and front presence 
speakers.

Once you perform the next operation, this unit starts the 
automatic setup procedure in 10 seconds. During the 
automatic setup procedure, do not perform any operation on 
this unit. For more accurate measurements, we recommended 
that you get out of the room or move to the wall where 
speakers are not around during the measurement. It takes 
approximately 3 minutes.

FRONT

DIRECTION