Integra DTR-10.5 User Manual

 

48

 

• Multiroom kits such as those made by Niles

 

®

 

 and 

Xantech

 

®

 

RF Receivers can also be used with the remote controller 
to control the DTR-10.5 from a remote location. To use 
RF Receivers, set the Transmission Signal Format set-
ting to “RF” (See page 141 for details).

 

If the DTR-10.5 is located inside a cabinet or other 
enclosure where the infrared rays from the remote 
controller cannot enter, then operation with the remote 
controller will not be possible. In such a case, it will be 
necessary to install a remote sensor at a location outside of 
the cabinet so that the infrared rays from the controller can 
be sensed.

 

The IR IN input allows you to control the DTR-10.5 
from the remote zone (Zone 2/Zone 3) with the remote 
controller even though the remote zone may be on the 
other side of the building from the main zone. The 
diagram below shows how to make the proper 
connections for the remote zone.

 

When connecting a multiroom kit, use the IR connection 
Phoenix (Pluggable connector) terminal (smaller one) 
supplied with the DTR-10.5.
Connect the ribbon cable from the connecting block to 
the IR connection Phoenix terminal.
1. Loosen the screws using a flatblade screwdriver to 

open the shutters.

2. Connect the white wire to the MAIN, ZONE 2 or 

ZONE 3 terminal according to the room where the 
multiroom kit is used, and then close the shutter.

3. Connect the red wire to the +12V terminal, and then 

close the shutter. If you use more than one multiroom 
kit in different rooms such as MAIN and ZONE 2, 
connect all the red wires to the +12V terminal 
together.

4. Connect the black wire to the GND terminal, and then 

close the shutter. If you use more than one multiroom 
kit in different rooms, connect all the black wires to 
the GND terminal together.

 

5. As shown in the illustration below, connect the Phoe-

nix terminal firmly to the IR IN socket on the 
DTR-10.5.

+12V

IN

GND

+12V

MAIN

GND

ZONE 3

ZONE 2