Sony 3-289-204-41(1) User Manual

120

C:\NORMAN\SONY HA\STR-DA2400ES\3289204411\04GB-STRDA2400ESUC\110ADD_GB.fm

masterpage: Left

STR-DA2400ES
3-289-204-41(1)

The TV’s remote commander cannot be
used to control the connected
component when using the Control for
HDMI function.

• Change the input of the receiver to the

HDMI input connected to the component.

Tuner

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 74).

• Press DISPLAY so that the frequency

appears on the display.

RDS does not work.*

• Make sure that you are tuned to an FM

RDS station.

• Select a stronger FM station.

The RDS information that you want
does not appear.*

• Contact the radio station and find out

whether they actually provide the service
in question. If so, the service may be
temporarily out of order.

Models of area code CEL, CEK, ECE only.

Receiver

To ground

Ground (earth)
wire (not supplied)

Outdoor FM antenna (aerial)