Sony 3-289-204-41(1) User Manual

C:\NORMAN\SONY HA\STR-DA2400ES\3289204411\04GB-STRDA2400ESUC\110ADD_GB.fm

STR-DA2400ES
3-289-204-41(1)

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure that the command modes of the 

receiver and the remote are the same. If the 
command mode of the receiver and the 
remote are different, you cannot operate 
the receiver with the remote (page 37).

• Make sure you select the correct input on 

the remote.

• When you operate a programmed non-

Sony component, the remote may not 
function properly depending on the model 
and the maker of the component.

If there is a malfunction, the display shows a 
code of two numbers and a message. You can 
check the condition of the system by the 
message. Refer to the following table to solve 
the problem. If any problem persists, consult 
your nearest Sony dealer.

Irregular current is output to the speakers, or 
the upper panel of the receiver is covered 
with something. The receiver will 
automatically turn off after a few seconds. 
Check the connection of speakers and turn 
on the power again.

For other messages, refer to “Message list after 
Auto Calibration measurement” (page 49) and 
“DIGITAL MEDIA PORT message list” 
(page 86).

All memorized settings

Customized sound fields