Mark Levinson 500H User Manual
Mark Levinson
10
Material Requirements
Note
Network Setup
The Nº500H series power amplifier supports a network connection
through the Ethernet port. The Nº500H series can connect to a
network through use of a router or directly to a computer.
through the Ethernet port. The Nº500H series can connect to a
network through use of a router or directly to a computer.
The Nº500H series can be:
1.
Connected to a router with DHCP active – We highly
recommend using this option. Since the DHCP (Dynamic Host
Configuration Protocol) automatically assigns the IP (Internet
Protocol) addresses, setup is much simpler.
recommend using this option. Since the DHCP (Dynamic Host
Configuration Protocol) automatically assigns the IP (Internet
Protocol) addresses, setup is much simpler.
2.
Connected to a router with DHCP not active – This method
requires more advanced networking knowledge to set up
because it uses fixed static IP addressing.
requires more advanced networking knowledge to set up
because it uses fixed static IP addressing.
3.
Connected directly to a computer with no router – We
recommend only using this option when a router is not
available. This method requires more advanced networking
knowledge to set up because it uses fixed static IP addressing
and a special network crossover cable.
recommend only using this option when a router is not
available. This method requires more advanced networking
knowledge to set up because it uses fixed static IP addressing
and a special network crossover cable.
This section provides general instructions for all three methods.
The following materials are required to connect the Nº500H series
to the network with a router:
to the network with a router:
• Nº500H series power amplifier
• Two twisted-pair network cables
• PC-compatible computer with 10/100Base-T network card
• 10/100Base-T router
The Nº500H series does not support wireless connection. However, a
cable attached from the amplifier to a wireless adapter can be used to
interface with a wireless network.
cable attached from the amplifier to a wireless adapter can be used to
interface with a wireless network.
The following materials are required to connect the Nº500H series
to a computer without the use of a router:
to a computer without the use of a router:
• Nº500H series power amplifier
• Network crossover cable
• PC-compatible computer with 10/100Base-T network card