Mark Levinson 500H User Manual

11

Nº500H Series Power Amplifier

The PC-compatible computer used to connect to the Nº500H series 
must have the following software installed:

•  Windows

®

 2000 or Windows XP

®

•   Web browser (Microsoft

®

Internet Explorer

®

 6.0 or higher 

preferred)

If DHCP is not active, the computer must be set up with a Static IP 
address. Refer to the “Setting Up the Computer” procedure found later 
in this section for instructions.

The Nº500H series can be connected to the computer in two  
ways – through a router or directly to the computer. Before 
connecting the cables, ensure that the computer and the amplifier 
are powered down.

1.   Connect a network cable from the router to the Ethernet port 

on the rear panel of the amplifier.

2.   Attach a second network cable from the router to the Ethernet 

port of the computer.

Use a 

network crossover cable to connect the amplifier directly 

to the computer. Different from a standard network cable, the 
crossover cable is designed to connect network access ports directly 
together without a hub, router, or switch.

Connect the crossover cable from the Ethernet port on the rear 
panel of the amplifier to the Ethernet port of the computer.