Mark Levinson 500H User Manual

Mark Levinson

14

If DHCP is not used, then the computer must be set up too. Use 
this procedure to set up the computer, then continue to the next
procedure to connect to the amplifier. For the computer to find 
the amplifier, the LAN (Local Area Network) and TCP/IP (Internet
Protocol) settings of the computer must be set up. The parameter 
setups vary slightly depending upon the operating system of the 
computer. Refer to the procedure below that matches the operating 
system on your computer.

Due to your preference settings in the Windows operating system, 
the names and order of the dialog boxes may vary slightly from these 
instructions.

1.   From the Start menu, select Control Panel.

2.   Double-click on the Network Connections option.

3.   Double-click on the Local Area Connection option.

4.    Click the Properties button to open the Local Area Connection 

Properties menu. If the computer is not currently connected 
to an active network, Step 3 has already opened the Local Area 
Connection Properties menu.

5.   Click on the Internet Protocol (TCP/IP) line item so that it is

highlighted.

6.   Click the Properties button.

7.   Select the “Use the following IP address” option. The IP

address, Subnet mask, and Default gateway boxes are no longer
grayed out and can now be modified.

8.   Enter the following values:

• IP address: 192.168.50.x – where x stands for a number

other than 0, 3, 4, 5 or 255

• Subnet mask: 255.255.255.0

• Do not enter a value in the Default gateway parameter

 

 The computer must have a unique address and be on the same 
subnet as the amplifier.

9. Click “OK” to save and exit the menu.

10. Open the Internet Explorer Web browser.

11. From the menu bar, select the Tools  Internet Options menu.

12. Select the Connections tab.

13. Click the LAN Settings button.

14. Verify that “Use a proxy server for your LAN” is NOT checked.

15. Click “OK” to save and exit the menu.