Mark Levinson 433 User Manual

22

Mark Levinson

Contact an authorized Mark Levinson dealer or Customer Service at 
www.marklevinson.com for additional assistance making Link connections.

Making Link connections creates a slave chain that facilitates 
communication among linked components, allowing them to share 
certain controls. 

All slave chains:

•

Must include compatible Mark Levinson components. The Nº433 
is compatible with the components listed on the previous page. 
Refer to the appropriate documentation for Link compatibility 
information for other Mark Levinson components.

•

Must include components that are connected in a certain order 
to prevent communication from prematurely terminating. 
Power amplifiers such as the Nº433 must be the last component 
in a slave chain.

The slave chains in this section include preamplifiers and power amplifiers. 
However, slave chains can also include digital audio processors and digital 
transports. Refer to the appropriate documentation for information about 
including these Mark Levinson components in a slave chain.

The table below indicates slave chain requirements for preamplifiers 
and power amplifiers.

Preamplifier
(e.g., N

o

320S or N

o

326S)

• No maximum number per slave chain. 

• Connect eight-pin to six-pin Link cable from the 

or slave out communication port on the 

preamplifier to the 

 communi-

cation port on the first power amplifier.

• Connect six-pin to six-pin Link cable from the 

 port on the N

o

32 pream-

plifier to the 

 port on the N

o

433 

power amplifier.