Dynacord 315 User Manual

14

Electronically balanced inputs for the connection 

of high-level signal sources, like for example mixer 

outputs.

Connecting signal sources via phone or XLR-type 

plug is equally possible. However, to avoid possible 

external hum and RF-interference, using high quality, 

high-performance shielded audio cables with XLR-

type connectors is always preferable

Connectors connected in parallel to the corresponding 

XLR-type inputs allowing the easy carrying through 

of input signals and providing the opportunity to 

directly connect an additional PowerSub 315 via these 

sockets.

CLIP LED indicates when lit that the internal power 

amp is actually driven at its limits. Short-term blinking 

is not critical, since the power amp’s audio limiter 

controls distortion down to a minimum so that it is 

not audible. Continuous lighting indicates that audio 

signals are already distorted in the input stage, which 

inevitably leads to sound degradation. Reducing input 

levels and lowering channel faders is an appropriate 

remedy.

SIGNAL LED indicates that an audio signal is 

present at the input. If no bass sound is heard, the 

SUB LEVEL control might be set at its lowest setting. 

Position the control at its center setting. If no sound is 

heard through the satellite systems, please check the 

speaker cables for correct connection.