Dynacord 315 User Manual

15

This switch lets you control the X-over frequency between subwoofer 

and Mid-High-range satellite cabinets. The factory setting (100Hz) 

is ideally suited for 12” satellite speaker systems. The 160Hz setting 

matches top cabinets and protects the 10” or 8” transducers’ diaphragms 

from mechanical overload. When employing top cabinets with 15” 

speakers, the 80Hz position mostly provides improved sound.

This control sets the volume of the PowerSub 315 in a setting range 

between -∞dB to +10dB, while 0dB marks the center position.

Always adjust the PowerSub 315’s output level as precise as possible 

and use the mixer’s bass controls for minor sound corrections only.

Outputs for the connection of satellite cabinets (e.g. 

DYNACORD D 12). Each output provides a power 

capacity of up to 500W into 4 ohms, offering the 

possibility of connecting up to two 8 ohms satellite 

speaker systems (e.g. DYNACORD D 12) per 

output.

This output socket is for the connection of up to 

two additional passive subwoofers (e.g. one or two 

DYNACORD SUB 115). Maximum output power of 

the output is 500W into 4 ohms, when the MODE 

SWITCH is set to ‘INTERNAL+EXTERN‘.

When set to ‘INTERNAL SUB ONLY‘, only the 

internal subwoofer is used and driven with 1000W /

8 ohms while the ‘EXTERNAL SUB OUTPUT‘ socket 

is switched off.

When set to ‘INTERNAL+EXTERNAL‘, the 

integrated power amps output power is distributed 

between the internal and externally connected, 

passive subwoofers. Compared to the ‘INTERNAL 

SUB ONLY‘ setting and despite the fact of power-

output distribution, this setting provides a little bit 

higher overall SPL because of the increase in the 

total diaphragm surface and the lower mechanical 

excursion of each diaphragm.