Fresco Speaker User Manual
Mounting the Fresco i On A Wall or Ceiling 7
Changing the Direction of Rotation
Figure 7. Remove the 2 cap nuts and washers from the hinges.
Figure 8. Remove the wall bracket from the cabinet bracket.
Figure 9. Remove the 2 set screws.
Figure 10. Change hinge pin locations.
Figure 11. Reinstall the two set screws to hold hinge pins in place.
Required tools (included):
2.5mm Allen tool, 6mm Allen tool
NOTE: This procedure can be performed either with
the bracket assembly installed on the Fresco i cabinet or
with the bracket assembly uninstalled. For the purpose
of illustrating this procedure, the bracket assembly is
depicted installed on a cabinet.
1 Ignore this step if the bracket assembly is not installed
the bracket assembly installed on the Fresco i cabinet or
with the bracket assembly uninstalled. For the purpose
of illustrating this procedure, the bracket assembly is
depicted installed on a cabinet.
1 Ignore this step if the bracket assembly is not installed
on the Fresco i. Prepare a flat surface with padding
and sheets to protect the speaker as you work on it.
Remove the Fresco i's grill cover and carefully place
the Fresco i face down on the work surface, using
books or pieces of cardboard to keep the speaker
from rocking.
and sheets to protect the speaker as you work on it.
Remove the Fresco i's grill cover and carefully place
the Fresco i face down on the work surface, using
books or pieces of cardboard to keep the speaker
from rocking.
2 Using the 6mm Allen tool, remove the 2 cap nuts and
washers from the hinges. Place them aside (see figure 7).
3 Carefully remove the wall bracket from the cabinet
bracket (see figure 8).
4 Using the 2.5mm Allen tool, carefully remove the 2 set
screws that hold the 2 hinge pins in place (see figure 9).
5 Move the wall bracket hinge pin to the outside of the
opposite hinge. Move the cabinet bracket hinge pin to
the outside of the opposite hinge (see figure 10).
the outside of the opposite hinge (see figure 10).
6 Using the 2.5mm Allen tool, reinstall the 2 set screws
to lock the hinge pins in place. Make sure the set
screw tightens against the flat surface of the pin (see
figure 11).
screw tightens against the flat surface of the pin (see
figure 11).
7 Reinstall the washers and cap nuts.