Fresco Speaker Manuel D’Utilisation

Changing the Direction of Rotation

Figure 7. Remove the 2 cap nuts and washers from the hinges.

Figure 8. Remove the wall bracket from the cabinet bracket.

Figure 9. Remove the 2 set screws.

Figure 10. Change hinge pin locations.

Figure 11. Reinstall the two set screws to hold hinge pins in place.

Required tools (included):

2.5mm Allen tool, 6mm Allen tool

NOTE: This procedure can be performed either with 
the bracket assembly installed on the Fresco i cabinet or 
with the bracket assembly uninstalled. For the purpose 
of illustrating this procedure, the bracket assembly is 
depicted installed on a cabinet.
 
1  Ignore this step if the bracket assembly is not installed 

on the Fresco i. Prepare a flat surface with padding 
and sheets to protect the speaker as you work on it. 
Remove the Fresco i's grill cover and carefully place 
the Fresco i face down on the work surface, using 
books or pieces of cardboard to keep the speaker 
from rocking.

2  Using the 6mm Allen tool, remove the 2 cap nuts and 

washers from the hinges. Place them aside (see figure 7).

3   Carefully remove the wall bracket from the cabinet 

bracket (see figure 8).

4  Using the 2.5mm Allen tool, carefully remove the 2 set 

screws that hold the 2 hinge pins in place (see figure 9).

5  Move the wall bracket hinge pin to the outside of the 

opposite hinge. Move the cabinet bracket hinge pin to 
the outside of the opposite hinge (see figure 10).

6  Using the 2.5mm Allen tool, reinstall the 2 set screws 

to lock the hinge pins in place. Make sure the set 
screw tightens against the flat surface of the pin (see 
figure 11). 

7  Reinstall the washers and cap nuts.