Sony RHT-G1000 User Manual
26
US
• If you resume play a disc when volume is
maximum, there may be no sound. In this
case, turn down the volume, turn off the
system and turn on again.
case, turn down the volume, turn off the
system and turn on again.
Sound is interrupted or there is noise.
• Check that you are not inputting PCM 96
kHz audio signals; this system cannot output
PCM 96 kHz audio signals.
PCM 96 kHz audio signals.
There is no picture or an unclear picture
appears on the TV screen.
appears on the TV screen.
• You have set progressive format on your
DVD player but your TV cannot accept the
signal in progressive format. In this case,
return the setting to interlace format on your
DVD player. For details, refer to the
operating instructions supplied with your
DVD player.
signal in progressive format. In this case,
return the setting to interlace format on your
DVD player. For details, refer to the
operating instructions supplied with your
DVD player.
• Even if your TV is compatible with
progressive format (525p/625p) signals, the
image may be affected when you set
progressive format on your DVD player. In
this case, return the setting to interlace
format on your DVD player. For details,
refer to the operating instructions supplied
with your DVD player.
image may be affected when you set
progressive format on your DVD player. In
this case, return the setting to interlace
format on your DVD player. For details,
refer to the operating instructions supplied
with your DVD player.
• Check that the TV is selected correctly.
• Set the TV to the appropriate input mode.
• Set the TV to the appropriate input mode.
TUNER
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely.
• Adjust the angles of the antennas (aerials).
• Connect an external antenna (aerial) if
• Connect an external antenna (aerial) if
necessary.
• Use manual tuning.
• No stations have been preset or the preset
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations.
scanning preset stations). Preset the stations.
FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
OTHER
The remote does not function.
• Point the remote at the remote sensor
on
the system.
• Remove any obstacles in the path between
the remote and the system.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Press ?/1 to turn on the power.
2
Press INPUT SELECTOR, VOLUME –,
?/1 at the same time.
?/1 at the same time.
“COLD RESET” appears and the system is
reset. AMP menu, sound field and the preset
radio stations, etc., return to the default
settings.
reset. AMP menu, sound field and the preset
radio stations, etc., return to the default
settings.
AM
ANTENNA
COAXIAL
FM
75