TEAC MCDV600 User Manual

Check the impedance of your speakers. Connect speaker with an 
impedance of 4 Ω or more.

The black speaker terminals are “_” (negative).
Generally, the “+” side of the speaker cable is marked to make 
it distinguishable from the “_” side of the cable. Connect this 
marked  side  to  the  “+” terminal and the unmarked side to the 
black “_” terminal.

Prepare the speaker cables for connection by stripping off 
approximately 3/8” (10 mm) or less of the outer insulation.
Twist the strands of the stripped wires tightly together:

 

The metal portions of the two separate wires should not touch or 
an electrical short can occur. Removing too much insulation may 
lead to a short circuit if the bared wired should come in contact 
with each other. Shorted wires can create a fire hazard or induce a 
failure in your equipment.

1.  Unlock the lever of the speaker terminal to connect the cable.

2.  Insert the wire into the terminal fully and lock the lever to 

securely connect it:

Make sure none of the wire insulation is inserted into the terminal, 
only the bare, stripped wire.

3.  Make sure it is fastened firmly by pulling the cable lightly.

<  Read the instructions of each component you intend to use with this unit.
<  Be sure to connect each plug securely. To prevent hum and noise, do not bundle the connection cords.